YUKEN疊加式溢流閥,好中國臺灣YUKEN疊加式溢流閥

YUKEN疊加式溢流閥,好中國臺灣YUKEN疊加式溢流閥

導泄油口避免連接導泄油口與可能的沖擊壓力線
Check that the drain back pressur
Toavoid preselected pressureinstability
為了進行流量調節松開鎖緊螺母
壓縮彈簧使閥瓣關閉只要下游無水流動
Sub-plates are available Specify
務必在調整后重新鎖緊螺母擰緊壓力
調整Pressure ControlState(2.6 U.
S.GPM)orhigher for nominal sizes

YUKEN疊加式溢流閥,好中國臺灣YUKEN疊加式溢流閥
然后打開流量調節螺栓順時針減小請
useapassing flow rate of10
dosenot exceed 0.2 MPa (29 PSI)
WhenRelief Valve Passing Flow Rate
當排水連接與制衡功能當個具有
閥背壓函數用于內部漏型背壓控制閥進行
ecause the minimum adjustment
pressure varies with the tanklin
e back pressure, add the tankline back pressure
to the value on the following lines
achined finish.更細的線路濾波器
外部導泄油型的導壓力必須始終超過主壓港“P”的壓力